| Re: WAP setting on a QTEK 8080
Cheers for that BDK. When I asked o2 they gave me the following, but altho its for an o2 x1 which is the same as a Qtek 8080 it doesnt seem to like it:
If you have an O2 X1, you will need to follow these instructions to manually enter the O2 Active settings into your handset.
Step 1 - CSD/GPRS WAP settings
Press Left Softkey (LSK) after entering each option
1.
Use the Red 'End Call' key to clear any text
2.
Menu (LSK)
3.
O2 Active (LSK)
4.
WAP Profiles (LSK)
5.
Choose an Empty Gateway Profile ? Press OK and enter the following details:
6.
Default: if it is the only profile ? this will be set
7.
Homepage: wap.o2.co.uk (. = # key x2)
8.
CSD:
•
Username: o2wap
•
Password: password
•
Dial-up Number: +447712927927 (+ = * key x2)
•
IP Address: 193.113.200.195 (Dots enter automatically)
•
Data Type: ISDN - use Green 'Call' key to select and Red 'End Call' key to exit
•
Data Speed: 9600 - use Green 'Call' key to select and Red 'End Call' key to exit
•
Idle Timeout: 3 Minutes - as above
9.
GPRS:
•
Username: o2wap (Pay Monthly users) or payandgo uk (if you have to top-up your phone)
•
Password: password
•
APN: wap.o2.co.uk (enter this if you pay monthly) or payandgo.o2.co.uk (Pay & Go users) (. = # key x2)
•
IP Address: 193.113.200.195 (Dots enter automatically)
•
Bearer: GPRS Prefer
•
Connect Mode: Continuously
•
Security: Off (untick with green ?Call? key)
•
Show Graphic: On
•
Rename: o2wap
Am I missing something fundamental? Those instructions I have used the data from to fit in where I can on the 8080. Really I am going to upgrade to something with wireless capabilities but amd not going to do that until I move house hopefullyin the next few months so just want soemthing to tide me over.
|