Chimney Breast

[CAS411]

Has anyone actually removed part of the brickwork of there chimney breast to instal there Plasma so that it sits flush ?

I am aware that a few people have built out the chimney brest to get a similar effect but space is at a premium in this small room and the only option that I can think of is to remove some brickwork and fit a new beam to support the remainder of the breast that is left.

Any thoughts on this appreciated

[mr-gobby]

I've considered doing it in the past (not only for a plasma) but decided against it. I agree it would attain a great deal of additional space though.

It can be done if you retain the structural integrity of the remaining stack above. The width of the breast would determine whether it's feasable or not as you need sufficient sides of the chimney to remain to take the lintel and support it there upwards. The construction of the chimney is also a factor. Perhaps get advice from a reputable local builder on the feasibility and cost implications.

Bear in mind the mess, redecoration and flooring implications on top of the builders estimate. Also consider a power supply location and aerial point.

[APatel]

cas411, i inquired about this about 6 months ago, turned out for my chimney it could be done but would basically mean knocking it down and rebuilding it :/

I must admit, the flush look does look great though, my only concern with the flush look is what happens when you get another tele and the dimensions are different, could be a problem.

like gobby says get a reputable builder in as all houses and chimney breasts are different

[keyjade]

cas, check out my installation from the link in my signature.

Is that what you are looking for?

[kingo]

Do what i did I removed the complete breast and then support the rest, you will be supprised how much more room you have, total cost for me was £500 and it was well worth the money the room is so much larger and placing that all important av equipment is much better.