[Member 254261]

Dear All,

Apologies if this is the wrong place to ask, but i'm at my wits end with this one! driving me bonkers

We have a requirement for displaying an image onto a pillar, obviously when we display the image it will become warped, so we have a requirement for a bit of hardware (other than the offering from calibre @ £3k) to 'bend' the image so when we display it onto the pillar it is then 'correct'.

If that makes any sense.

Don't worry about whether its HDMI / Component / Composite / etc... we can sort that lot out!

any pointers / directions / suggestions would be very well appreciated.

Kind Regards,
Dave

[Joe Fernand]

You could always pre distort the image during the post production stage - otherwise look for a video wall controller that does a 1x1 mag and allows you the level of manipulation you require; low end units wont do.

Joe