Cable required to upgrade firmware on Rotel RSP-1068?

jon smith · 01-03-2007, 1:27 PM

Does anyone know where I can get hold of a cable to upgrade the firmware on a Rotel processor (one that works with the 1068)

It's a special RJ45 to 9 pin D connector cable, will only the Rotel one work or is there another cheaper alternative I can buy?

Fishbones · 02-03-2007, 2:50 PM

It's not the standard RS232 DB9 to RJ45 cable. You will have to DIY or buy from Rotel.

Regards

PS. Not sold yet ?

jon smith · 02-03-2007, 4:19 PM

Thanks for the info... Has been sold, just trying to track down the cable for the new buyer.

hemp3 · 08-10-2009, 8:17 AM

Can anyone give me some more information on this. I bought the processor in 2004 and havent upgraded the software since. Does anybody have a cable i could borrow if i paid for postage?

hemp3 · 28-12-2009, 1:19 PM

Can anyone give me any info on the cable needed? Will one like the one below work?

http://www.lextec.com/images/cus_rj45-db9f_lg.jpg

SSB · 14-01-2010, 5:14 PM

Have you checked in the box - I received one with my RSP-1066?

If not, I'm sure I could lend you mine if you paid postage both ways.