Urgent Question !! Unicol bracket for 42" Panny Series 5

[MontyUK]

Evening all,

I've just put my Unicol wall-bracket up (the flat, non-tilt variety) in advance of my new panel arriving during the week . .. but realise I've made a fairly serious assumption . . .

Can anyone confirm whether the centre of the bracket on the wall aligns to the centre of the panel (vertically) when it's hung on it ???? If not, whats's the difference, and which way ???!!!!

Cheers,

Monty.

[jmack]

yes its dead centre the 42 plasma over hangs the side of the mount about 7inches on each side
hope that helps

[MontyUK]

Is that 7 inches top and bottom you're talking about Jmack, or side to side ?

Er, just realised my original post should have said 'horizontally' . . . it's the height I'm worried about :blush: Can you confirm for me height-wise ??

Thanks in advance,

[jmack]

7inches <-------------->
about 3 1/2 from top and botom

if you would like i will email u a piture from the side and top

[MontyUK]

cheers JMack . . so it is even then, top and bottom, ie the centre of the unicol bracket is the same height as the centre of the screen ? That's all I'm worried about really . . .

If so, that's my mind put at rest :)

Thanks,

[jmack]

i would not say excact even i would say about little diff
maybe 3 1/2 inch at top 4 or 5 at bottom its hard for me to measure the bottom so going by eye

[MontyUK]

ok, should be close enough hopefully . . . thanks for your help JMack.