Barco Data 708 will not light up; possible eht problem?

Hello Everyone,
Projector stopped showing images and was giving an EHT holdown signal.
I switched out the quadrupler but no improvement.
I switched out splitter, projector returned to normal, placed back into operation.
About an hour later pj was not projecting again, this time no error or fail signals.
As of now CRTs all glow faintly at their base but no image at all in the tubes and all indicators are green.
Any bright ideas?
Thanks,
Jason Zermeno

[echosat]

i have a 708 with burned tubes in working order if u are interested make me an offer maybe of use to u

Originally Posted by echosat

i have a 708 with burned tubes in working order if u are interested make me an offer maybe of use to u

My apologies if i am using this forum clumsily but I'm a newbie. Where are you located? We might be interested but I will have to get back to you with an offer.
Jason Zermeno

[Tom.W]

Jason did you replace the splitter with the recommended splitter for this projector ? I would try another just to be sure the replacement splitter you first installed was not defective and perhaps just failed.

[echosat]

Originally Posted by jzerm

My apologies if i am using this forum clumsily but I'm a newbie. Where are you located? We might be interested but I will have to get back to you with an offer.
Jason Zermeno

it also has iris 2 only trouble is the tubes are shot