Barco 600 vision No HV

[Aaron]

Hello,

I have a barco 600, recently i was watching movie, after 20 min it gives up no High Voltage I checked the MOSFET's and darlington it seems to be ok checked the power supply board and resolder the leads but no luck.
Is there anyone who have the diagram of the HV board or any service manual or any ideas where i can get.

[javers]

Hi Aaron, have a look at the status leds below the focus controls, whats their status? From memory I think all yellows should be lit, and if the red is too thats bad news. Again going from memory red means scan fail or hv hold down.

Jon

[Aaron]

Originally Posted by javers

Hi Aaron, have a look at the status leds below the focus controls, whats their status? From memory I think all yellows should be lit, and if the red is too thats bad news. Again going from memory red means scan fail or hv hold down.

Jon

Hi Jon, Thanks for fast reply.

Yes i checked the led status all are lit including the red led
what can i do?

[Roland @ B4]

Scan fail is loop that goes around all of the boards to make sure that they are present and seated correctly. I'm afraid your problem is more than likely either the H or V deflection borads