HD Upgrade Warning!

binbag · 10-12-2004, 5:20 PM

I've just upgraded the firmware on my HD to the latest version. HD-5.6-1.42

When I followed my usual power up routine, my projector bulb blew the moment that I turned on my audio amp. As I followed the same routine that I do every couple of days and have since re-checked that all the connections are correct my concern is that the upgrade is the cause of this ( I don't believe in coincidence).

My projector is an Infocus LP350 and it is connected to the HD via DVI-D through a Lindy adaptor.

I have informed DVDO of the above. I know Infocus PJ's are'nt the best for bulbs reaching their full life expectancy.

binbag.

10-12-2004, 5:20 PM	#1 (permalink)
binbag Senior Member Join Date: Jun 2004 Posts: 1,067 My movie collection iTrader: (8) Thanks: Gave 19, Got 33	HD Upgrade Warning! I've just upgraded the firmware on my HD to the latest version. HD-5.6-1.42 When I followed my usual power up routine, my projector bulb blew the moment that I turned on my audio amp. As I followed the same routine that I do every couple of days and have since re-checked that all the connections are correct my concern is that the upgrade is the cause of this ( I don't believe in coincidence). My projector is an Infocus LP350 and it is connected to the HD via DVI-D through a Lindy adaptor. I have informed DVDO of the above. I know Infocus PJ's are'nt the best for bulbs reaching their full life expectancy. binbag.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode


AVForums.com is the UK's biggest & best home consumer electronics discussion resource	New to AVForums.com? Start by reading our introduction here.
Search AVForums.com